B0401-00602BK

UTV Turn Signal Kit with Horn Functions&Troubleshooting

1.Are there turn signal indicator lights on the column switch?

This product is not equipped with a turn signal indicator on the steering column switch.

2.What is the specification for the fuse?

The fuse is 10A.

3.What size relay you use for the flasher relay on this blinker kit?

The relay is JD2012-1Z-12VDC, 40A 14V DC while the flasher is 12V, 0.02-20A. Please refer to the specifications shown on the photo.

4.Hole size for lights?

The hole size for lights is about 20.3mm.

5.Can you tell me if the turn signal with blink or is it just a steady light?

The turn signal is with blink, not a steady light.

6.What are the lengths of the wires?

Please refer to the below photo to check the lengths of the wires.

7.I would like too have 4 red lights for turn signals in the rear & splitters to hook then up, can this be done?

Yes, this could be done.

8.Turn signals don’t work / don’t flash.

Please follow these steps: ① Check all wiring connections are secure; ② Confirm vehicle voltage is 12V; ③ Swap the non-working light to the other side to determine if it’s a light or controller issue; ④ Check if the fuse is blown; ⑤ If all above are normal but the light is not working normally, then please contact us through support@kemimoto.com and send a video to show the issue.

9.Turn signals flash too fast / too slow.

① Confirm vehicle voltage is 12V (voltage fluctuations affect flash rate); ② Non-original LED lights may cause mismatch; ③ Check the fuse. Contact us if the issue persists.